D2 Manual Multicore Wire Stripper:

MK 6

New product

A quick and simple solution to multicore wire stripping suitable for production wire stripping.
By a single pull on the handle, precision die blades strip off the
outer insulation and secondary blades strip the inner conductors to preset
dimensions.
The D2 Wire Stripper is effective with PVC, Neoprene, Rubber and comparable insulations

More details

Ordering

To order this item or for further information please get in touch.

We are happy to answer any questions you may have and can supply orders of any size, from a single component to an entire factory floor.

Contact

Online: online form

Email:

Phone (UK): 07768 361444

Phone (Intl): +44.7768 361444

More info

In April 2015 there was a new D2 Multicore Wire Stripper Machine which has a larger blade set to accommodate up to 15mm outer diameter due to the opening of the blades. The maximum core diameter is 9.5mm. For core stripping, the adjustable inner blade will only open to a maximum of 3.5mm O.D.
On the 4 position blade sets you will be able to have a combination of sizes on the
blade set up to and including 9.5mm O.D (example: 4mm, 7mm, 8.5mm & 9.5mm O.D. stripping holes). For
sizes above 9.5mm you would need to order either a one or two sided blade set to maintain structural strength.

D2 Manual Outer Jacket and Inner Conductor Stripping Machine - Simple Set Up & Operation:
The outer jacket is stripped by selecting the nearest size of outer jacket die blades from the four position die
blade set and setting the rear length stop to the correct strip length.
The outer jacket blade holder is adjustable for cable diameter variations. As the outer jacket is stripped, the inner conductors are drawn
through a set of pinch rollers which hold them in position for stripping by a set of flat blades in the secondary stripping operation.
These blades are also adjustable for conductor diameter and are set to operate at the required position by adjustment of a cam operating lever.  Once set, the cable can just be laid into the unit and with a single pull of the handle, the outer jacket and inner conductors are stripped with a cycle time of a few
seconds.
The 3 stages of the wire stripping process can be seen in the photos below.
Special blades for flat, oval and non-standard conductors are also available.
By simply disabling the secondary stripping function the D2 can be used as an outer jacket stripper only.

D2 Multicore Wire Stripper Technical Data:
Cable Diameter Range: 3-10mm O.D. (up to 7.5mm Core Size)
Standard Blade Set Hole Size: 3, 4, 5 & 6mm
Special Blade Sets: Available on request
Maximum Outer Jacket Strip Length: 165mm (Longer if no inner strip required).
Size: 380 x 275 x 120mm
Net Weight: 4.25Kgs
Gross Weight: 4.75Kgs
Machine Warranty: 12 Months